.

So, as many of you know, even though I am a straight guy (never had even a slightly ambiguous gay experience in my whole life!) I am a little obsessed with foreskin. Mostly, my own, but also any nice example I see on the web or even in real life.
As I began to pump more frequently I became less and less interested in my cock per se, but rather trying to pump my balls to their maximum size. Invariably though, you can't pump your balls without pumping everything else, and I began to notice that depending on how I pumped, I could achieve drastically different results as far as my foreskin was concerned. When I pumped with it pulled over my head, it would tend to form an ever thickening and lengthening pucker, but when I pulled it back to pump out my head, it would get a bit of a 'donut' thing going on, with lots of swelling in the loose 'wrinkles' behind my head, but not as much along the shaft. After a point, it started to look kind of weird, and it would start getting irritated where it joined up along my frenulum.

I started experimenting, and I gradually came to figure out a sort of 'routine' for developing a thick and long foreskin. If you are uncut and into pumping, this may be of interest, but let me know what other ideas and opinoins you might have.

So, for pumping a full foreskin, I usually start off with a short session of 'normal' pumping. foreskin over the head, everything loose and well-lubed, and just enough pressure to get a bit of swelling throughout. Once I feel like my head is starting to swell a bit, I stop, loosen up with a quick break, and then start a short but intense session with my skin pulled back all the way. I do this at pretty low pressure just long enough to get my head swelling nicely. Flexing to flare my head out seems to help a lot. Once my head is pretty full, I stop again, and this time I lube up like crazy, especially under my foreskin, and then I try and bunch it up as much as possible around the tip. If your skin is long, this should be easy, it not, one trick that seems to work which I use anyway is to wrap a hair elastic or rubber band around your skin once it is bunched up tight. This should be done only to the extent that it will hold your skin together over your head while you get back into the cylinder and pump enough to create a good seal. Normally, this tends to pull your skin back a bit, but if you use the elastic you can avoid that inevitable pull-back. The important thing is that you do it so that as soon as you pump out enough air to start swelling up again, your head flares enough to spread your foreskin and roll the elastic off. DO NOT pump with an elastic around your skin!

I usually pump like this until I can tell that my head is starting to max out in terms of swelling,and typically by now my foreskin is pretty fat and 'erect", as in it tends to stick out pretty straight from the end. Full, heavy, thick, but no donut!

A final technique that I am loving for really working towards the ultimate in full and thick coverage (my goal is to still have a full coverage and a complete pucker even when I am pumped and rock hard) is stretching while pumping. I have a little silicone cup that is basically shaped like a cone, with the big end open and tapering down to a closed tip. I found it a pharmacy, and they sell it (WEIRD OUT ALERT!) for girls to use as a sort of reusable tampon. It is called the Keeper Cup and they make it in two sizes. The small one is pretty good for most stretching, and the big one is almost too much for me.

Once I am pretty pumped, I take the cup, fold it
in half, and slide it into my puckered foreskin. Once I let it go, it snaps open and voila! a soft, tight and comfortable seal! Because the cup is cone shaped and hollow, if you use enough lube, it invariably will slide down onto your head while your skin wants to slide up and over it. It still is wide enough that I am feeling like I am stretched out to the max, but at the same time, the more I pump and the longer my skin stretches, the more it wants to pucker down as it approaches the tip of the cup, so no big loose opening.

Using this technique I have had incredible results, and I would highly recommend it to anyone interested in pumping their forekin for pleasure, or restoration or any other reason at all!

When I finally pull out of the pump, I have a huge sac, a hard cock, and a super thick foreskin that fully covers my head, but still tapers down to a nice tight pucker at the end. I love it, GF can't get enough of sucking it, and the sensation of a fat tight foreskin rolling over my swollen head when we have sex is unreal. Of course, as with all pumping, the intensity of the inevitable orgasm is drastically intensified and while my GF loves feeling me cum inside her, one of the really fun things you can do with total coverage even when you are hard, is to cum inside your foreskin. GF isn't much into facials, but one of her (and my!) favourite things to do when I am ready to cum is to bunch of my foreskin over my head, gently bite it shut, and make me blow my load into my foreskin. It bulges up like crazy, but of course it eventually leaks out, and then she takes my whole head into her mouth to clean it off by sliding her tongue under my foreksin and sucking all the cum out. When she does this just giving me head, I can go from totally flaccid to rock hard, cum, and even get cleaned up all without ever pulling my foreskin back!

Let me know if any of you haver other tips or tricks, and look out for the next installment: Pumping with a Partner!

Comments

Blog entry information

Author
forrskin
Read time
5 min read
Views
141
Comments
2
Last update

More entries in General

More entries from forrskin

  • .
    I am wondering what other folks have to say on the topic of pubic hair...
  • .
    I posted the last few installments in a sudden burst of inspiration...
  • .
    So to continue the thread from my last post - Pumping with a Partner -...
  • .
    When I first started pumping, I was pretty careful about it, and I...
  • .
    I decided to post this blog for people that are interested in pumping...

Share this entry