2"x9" vacuutech flared cylinder

[pomdrinker]

Hi everyone. I recently received a 2"x9" cylinder from vacuutech. I though I measured correctly but it seems that when I place the cylinder over my shaft it won't easily fit through the opening near the base of my dick. I have a bit of curve to the left but at the base i have to twist the cylinder a little then slide it down to the create the seal. The measurements i took to figure out what size to order were 6.2" x 6.1". What is a good way to create and maintain a seal?

The reason i want to do some pumping is that i'm hoping to straighten out the slight curve to my penis and hopefully gain a little girth in the process. Also, not sure if anyone agrees with me, but i really do enjoy the sensation that pumping gives. I haven't pumped up to 5Hg yet, i've been sticking to around 3Hg. I'll leave it on for a five minutes then take it off and then massage. By massage i mean i'll stroke it with some vitamin e oil as if i'm masturbating. Is there a better massage technique that i should employ? During one session I think I massaged too much (while watching some porn) and ended up ejaculating in the tube. I didn't really feel it coming on but all of sudden I started to cum.

And thanks for the info on this site, very helpful stuff most of it is...

 

[B_ZACKD89]

Jelqing is the better massage technique.

Jelq and Jelqing - Penis Enlargement Manual

 

[Rikter8]

I usually will shave the area around the sealing surface with the tube, and use lots of lube. I prefer to use a Penetrating lotion instead of lube. THe lotion is good for your skin, makes it pliable and adds nutrients.
Can you take a photo of what you are speaking of? I think I know..but would be good to see.
Your supposed to enter the tube soft, then pump up to an erect state, slowly.

Others have used a stretchy silicone pump ring with success...but I've always had good luck with lots of lube where the tube meets the skin.

 

[pomdrinker]

Thanks. I'll be pumping tonight. I'll take some pics.