Cock head

[thedownlow]

What’s small avg and large for the head? Who’s packing a monster head?

 

[MiracleGro]

I'd say huge is any measurement beyond 2".

 

[1337357]

length or width?

 

[thedownlow]

Width. Circumference

 

[1337357]

no clue about avg width or circumference; i’m 6ish inches in circumference around the head; my head length is over 2 inches.

 

[thedownlow]

3.5 circumference and maybe 3/4 of an inch long

 

[deleted716371]

I'd say the average size of the head typically follows the average width of the cock, however some are smaller and some are bigger?

 

[4357]

I’ve got a prominent head. But I wouldn’t know how to correctly measure and it sounds like there’s some confusion on the subject with others too.
What’s the consensus?

 

[Raregentleman82]

idk what would be classified as big or medium i guess u tell me

 

[1119457]

Look at this Daddy's cock at the urinal . Talk about a huge apple head . Bet it would be hard to open your mouth that wide
View attachment 480P_600K_88719801.mp4

 

[74758]

Mine measures 2 3/8” long, 2 3/8” wide, and is 7” around. Above average lol...

 

[thick_]

6 1/2” circumference so on the large size.

 

[goander]

 

[T71R]

Mine:

 

[elfin9doug]

My cock head size is within the normal proportional relationship to the rest of my cock. Since my penis itself is large (in the top one percent in size), I would say my cock head is large.

 

[basque9]

This is how I measured the length of my cock head because when I measured with the tape lying on top of my cock head I got an inflated measurement of length. I aligned both tape end and bottom of cock head with the table edge. This also removes any distortion that might be caused by my cock being closer to the camera than the tape. Is 2 7/16 inches.

 

[deleted1168963]

What’s small avg and large for the head? Who’s packing a monster head?

Mine is almost 8” around

 

[Nosuportneeded]

We could measure the corona/coronal ring circumference? Circumference is hard to pinpoint.

Length and width are tough too, but you know when you’re cheating. Length at longest point/width at widest? Making sure not to measure curves or diagonals. The quarters give good reference too

I think anything longer and or wider than 1.75” is getting fairly large