Cock Ring

HotBulge

Worshipped Member
Joined
Jul 27, 2005
Posts
2,331
Media
108
Likes
17,265
Points
518
Age
34
Location
Lowells talk to Cabots, Cabots talk to God
Gender
Male
I wear metal cockrings quite often and, on occassion, have had sex with them on. It can become as comforatable as wearing jewelry. I've become accustomed to wearing two at a time: the inner one is one size larger in diameter than the outer one so that they both stay on.

I encourage the purchase of a metal cockring. for the quality and weight. Someone previously mentioned GearEssentials, and I also cast my vote. Elastic rings may be easier to put on and remove, but i find that they can constrict too much. Leather straps are helpful for their adjustability, but the leather may react with one's skin. Use a leather cockring as a trainer for a metal cock ring.

Some points to consider:

1] Good Fit - make certain that you take the proper measurements of your cock's circumfrence to ensure a good fit. Use a flexible sewing measure or a piece of string and wrap it once around the underside of your balls and the top your shaft to get the circumfrence. Recall

Circumfrence = (PI) * Diameter or

Circumfrence/PI = diameter


You will probably get a result around 1.75 to 2 inches in diameter. For comfort, be sure to round up to the next 1/4 inch.

2] Put them on in the shower - it saves time and prevents the touch of cold metal against your skin :smile: . Shaving your balls will eliminate the accidental tearing of pubic hairs.


3] Monitor the swelling in your cock - VERY IMPORTANT to do. If you have problems with blood clotting or blood thinning, don't even risk wearing a cock ring. If you are in decent health and try one, realize when the point of swelling has gone too far. It's not uncommon to feel a little burn or heat as blood flows into your cock, but if your cock starts to feel cold, you need to get the circulattion flowing again. Readjust the cockring and gently rub your cock to get blood to return. Try and make yourself less excited as well.

When wearing a cockring for extended periods of time, it's fine to stroke it occasionally.

4] Wear the appropriate underwear -- I personally think only 3D pouch underwear is appropriate when sporting a cockring. In part, it's for form, but even moreso for function. A nicely filled pouch looks good, but you need to have support over time when walking around.

- Don't wear underwear that is too tight or skimpy. It will make the feeling of constriction worse. 2xist has been for providing support while allowing for expansion.


5] Be mindful of Morning Wood - I've found that the cockring can cause the most pain and feeling of constriction while experiencing morning wood. It may be helpful to relieve one's self in the middle of the night to reduce the volume of one' s cock in preparation for morning wood.


6] Getting it off - Sometimes, the only way to really get the cockring off is to shoot a load. If it's absolutely necessary to remove the cockring in time for something else (e.g. going to the airport), leave some additional time to take care of business.
 

HotBulge

Worshipped Member
Joined
Jul 27, 2005
Posts
2,331
Media
108
Likes
17,265
Points
518
Age
34
Location
Lowells talk to Cabots, Cabots talk to God
Gender
Male
Lex said:
I have never been able to figure how to put the metal ones on.

Ericbear--how is this done? also-how do you take it off?


Your cock needs to be supple before attempting to put the metal cockring on. Your scrotum should lalso be nice and loose because you will essentially be "threading" your cock through the hole of the cockring. Take one of your nuts and place it through the hole; maintain its position on the other side. With the other nut, thread it through the hole until your balls are securely on the other side of the whole.

** With a limp shaft press down on your cock's head (the frenulum) and push it through the hole of the cockring. You may want to use a little lube with this or take advantage of the shower. A 7inch cock can do this.

To remove the ring, your shaft needs to be supple again. Push your shaft back through the whole and then take the ring off of the nuts.