Diameter

Discussion in 'Show Off' started by D_Garmanswait Glassnads, Nov 17, 2008.

  1. D_Garmanswait Glassnads

    Joined:
    Mar 5, 2007
    Messages:
    687
    Likes Received:
    2
    I've added a close up of me measuring the width of my penis. It clocks in at 2" or 5cm. Is that wide? I would do circumference but I don't have a tape measure, only a flexi ruler.
     
  2. crescendo69

    Gold Member

    Joined:
    Aug 27, 2006
    Messages:
    8,135
    Likes Received:
    31
    Gender:
    Male
    Location:
    Knoxville (TN, US)
    Seems wide to me.
     
  3. w2m4m

    w2m4m New Member

    Joined:
    May 21, 2008
    Messages:
    28
    Likes Received:
    0
    Gender:
    Male
    Location:
    Arkansas
    here's a tip:

    Take a strip of paper, wrap it around your dick when hard, matching end to end. Mark it with a pencil. Take it off and measure it with a straight ruler, then you'll have the circum.:cool:
     
  4. D_CountdeGrandePinja

    D_CountdeGrandePinja Account Disabled

    Joined:
    Feb 4, 2008
    Messages:
    9,757
    Likes Received:
    68
    it's fine, just as it is!!!!!
     
  5. Midwest Big Dogg

    Midwest Big Dogg Active Member

    Joined:
    Sep 8, 2008
    Messages:
    219
    Albums:
    1
    Likes Received:
    43
    Gender:
    Male
    Location:
    Kansas City (MO, US)
    I doubt you're able to accurately estimate the diameter by eyeballing it, but if you did accurately peg it at 2 inches, then the circumference is simply diameter x pi (3.14), or 6.28 inches for your estimated 2 inch diameter.
     
  6. D_Garmanswait Glassnads

    Joined:
    Mar 5, 2007
    Messages:
    687
    Likes Received:
    2
    It's not a circle though, but close enough, it'll be a little smaller then 6.28".
     
  7. Ineligible

    Ineligible Member

    Joined:
    May 11, 2004
    Messages:
    438
    Likes Received:
    0
    Gender:
    Male
    Location:
    Australia
    Usually it's wider than it is deep, though how much difference there is varies. As well, it's very hard to get an accurate measure of diameter with a ruler, because of parallax. The paper strip method for finding circumference gives a more accurate measure of thickness.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice