Did he measure wrong?

MaryAnneL

Experimental Member
Joined
Dec 5, 2006
Posts
16
Media
2
Likes
4
Points
148
Location
USA
Sexuality
100% Straight, 0% Gay
Gender
Female
So what is the "standard" way to measure? Embarassed to say that I havent actually seriously measured a guy before so are there specific ways it should be done?
 

BigA

Experimental Member
Joined
Jun 9, 2006
Posts
821
Media
0
Likes
8
Points
163
Age
42
Location
you won't find me
Sexuality
99% Straight, 1% Gay
Gender
Male
I think it's agreed upon that you measure from the top -- where the base of the penis meets your pubes (bottom of your abdoman). However, I am not sure if it is accepted to push, apply pressure with the ruler, into your skin. For instance when I don't push, I am an honest (meager) 6 inches. But if I push into that bit of cushy flesh I can get 6.5. Anyone care to clarify/ elaborate..
 

fowfer

Sexy Member
Verified
Gold
Joined
Mar 16, 2006
Posts
379
Media
0
Likes
49
Points
348
Verification
View
Sexuality
Unsure
Gender
Male
BPEL = Bone Pressed Erect Length which elimates the fat pad variable. When measuring for gorwth or other comparisons you want as few variables as possible. Therefore, you should measure with a ruler and a rock hard from the pubic bone(pressed) to the end of the head(do not include forskin)
 

AlbertCunning

Expert Member
Verified
Gold
Joined
Nov 10, 2006
Posts
340
Media
20
Likes
138
Points
363
Location
Drammen (Buskerud, Norway)
Verification
View
Sexuality
100% Straight, 0% Gay
Gender
Male
awesome. i can honestly say 6.5 then! i didn't wanna cheat:biggrin1: I'm such a stud

Amen to that.
I don't have much of a fat-pad myself -- I generally have very little fat on my body-- but even I was able to gain almost a quarter of an inch whilst pressing in, and make it a 6,5".

But will I give up that measurement if the group in general finds this a faulty way of measuring?
Probably not.
 

Randll86

Superior Member
Verified
Gold
Joined
Aug 10, 2006
Posts
614
Media
80
Likes
3,224
Points
598
Location
Tampa (Florida, United States)
Verification
View
Sexuality
100% Straight, 0% Gay
Gender
Male
I measure from where my dick bends at 90 from my body placing ruler on top not pushed in, I was told this is the correct way to measure, I am about 8.5" measuring that way (pic in gallery) however If I point my dick slightly down & push into the bone measuring along curve I am over 9.5" close to 10". Although who is to say what is the right or wrong way, I don't think there is a rule is there?:rolleyes:
 

episcalo

Experimental Member
Joined
May 15, 2006
Posts
62
Media
3
Likes
11
Points
228
Sexuality
100% Straight, 0% Gay
Gender
Male
3" wide is reallly reallly rrrrreeeaallllllyy big. I'm 2.2" wide (7" circumference), you can compare with my picture to see.