Pick your GIRTH?

Is your GIRTH ?

  • Below 3 inches

    Votes: 11 0.4%
  • 3.1-4 inches

    Votes: 12 0.5%
  • 4.1-4.4 inches

    Votes: 36 1.4%
  • 4.5-4.8 inches

    Votes: 126 4.9%
  • 4.9-5.2 inches

    Votes: 305 11.9%
  • 5.3-5.5 inches

    Votes: 420 16.3%
  • 5.6-5.8 inches

    Votes: 431 16.8%
  • 5.9-6.2 inches

    Votes: 636 24.7%
  • 6.3-6.6 inches

    Votes: 334 13.0%
  • above 6.7 inches

    Votes: 261 10.1%

  • Total voters
    2,572

B_andyo

Sexy Member
Joined
Apr 18, 2007
Posts
1,928
Media
0
Likes
39
Points
183
Location
Miami
Sexuality
100% Straight, 0% Gay
Gender
Male
what do you guys use to measure...? I think a shoe lace is bad because it will add you a few cm..


btw this poll is not getting some belief .... the poll has a curve whcih tops at 6 inches.. and then gradually fell down.. but the 6.7+ is a mistery since it almost is equal to 6.3-6.6 :)maybe if i take 8% of the 6.7 is more accurate!
 

gboy

Just Browsing
Joined
May 20, 2007
Posts
10
Media
0
Likes
0
Points
146
Gender
Male
I guess that maybe I should do this, since so many people are intrigued by this. I usually get a good open eyed look when undressing and during foreplay.
 

Scott8361

Mythical Member
Verified
Gold
Joined
Nov 9, 2004
Posts
2,722
Media
1,737
Likes
44,717
Points
618
Location
Milwaukee (Wisconsin, United States)
Verification
View
Sexuality
80% Straight, 20% Gay
Gender
Male
Someone taught me the Dollar Bill method.
A Dollar Bill = 6"
When I wrap it around my shaft, there's about 1/2" gap.
So I say I'm 6 1/2" thickness/girth.

Look at my photos.... I have a picture using the dollar bill method...

LOT'S of overlap for mine! Pretty pathetic if you ask me.:mad:
 

B_andyo

Sexy Member
Joined
Apr 18, 2007
Posts
1,928
Media
0
Likes
39
Points
183
Location
Miami
Sexuality
100% Straight, 0% Gay
Gender
Male
the graph have some meaning... hmm but i think the 6.7+ mark should be little less than 10% most of the people in here are fat cocks but not that many..
 

AlbertCunning

Expert Member
Verified
Gold
Joined
Nov 10, 2006
Posts
340
Media
20
Likes
138
Points
363
Location
Drammen (Buskerud, Norway)
Verification
View
Sexuality
100% Straight, 0% Gay
Gender
Male
At 6.25" I had to pick the 5.9-6.2" range because I didn't want to be accused of stretching the truth into the 6.3+" range.
Same here.
At maximum hardness, I'm 6,3"-6,4" at the base, but overall, I prefer to represent the high end of 5,9"-6,2".

It seems that both length- and widthwise, I represent the average of our little club, as 6,9"-7,4" so far looks like the average length.

I'm really in the same position when it comes to length. Bone-pressed, measured along the upper curve, I am 7,5-ish, but I prefer to call myself a genuine 7-incher(18cm at LEAST).
Hell, when I joined, my perception was that my penis was only about 6,5"; as it curves SIGNIFICANTLY upwards(I was also far from bonepressing). But when I realized that at 90% hardness(or thereabouts), which leaves my penis to point almost straight out, I was very close to 7", I realized that I had in fact misrepresented myself.

I'm ranting again, I know, but I find it UNFAIR that those with DOWNWARD curved erections should be allowed to submit their upper curve measurements, as we with UPWARD curves aren't allowed to submit our lower ones.
My lower curve is no less than 8".
Not much more either, I must admit.

I realize that the flaw of my argument, is that there really is no bone to measure from at the underside.
I tiny flaw.
 

B_andyo

Sexy Member
Joined
Apr 18, 2007
Posts
1,928
Media
0
Likes
39
Points
183
Location
Miami
Sexuality
100% Straight, 0% Gay
Gender
Male
nice.. so afr the curve of the grapgh is perfect " it is a bell curve" yea the average of this site must be around 6.. an 90+% fall between 5-6.5 inches