Pumping Question..help

Stayinlonger

Experimental Member
Joined
Mar 6, 2019
Posts
22
Media
0
Likes
20
Points
13
Location
Ontario (Canada)
Sexuality
100% Straight, 0% Gay
Gender
Male
Can someone here please tell me how to stop the swelling bulging just below the head when pumping..I can go from 5 inch girth to 6 no problem but anything over that the swelling happens...it nice to have sex when its pumped to 7 but the swelling make it uncomfortable for the my partner..
 
  • Like
Reactions: Leobakker

engineer805

Legendary Member
Joined
Jul 28, 2019
Posts
415
Media
11
Likes
1,380
Points
438
Location
Ontario, California, US
Sexuality
99% Gay, 1% Straight
Gender
Male
A wide rubber band of appropriate diameter will do the trick, but "appropriate" will need to be experimentally determined by you. Place it so the upper edge of the band follows the lower edge of the glans (head).
 

engineer805

Legendary Member
Joined
Jul 28, 2019
Posts
415
Media
11
Likes
1,380
Points
438
Location
Ontario, California, US
Sexuality
99% Gay, 1% Straight
Gender
Male
And I agree that sex, for both you and your partner, is enhanced right after pumping. I find that, if I pump longer than about 20 minutes, there's some de-sensitization which can delay orgasm ... usually a good thing!
 

Stayinlonger

Experimental Member
Joined
Mar 6, 2019
Posts
22
Media
0
Likes
20
Points
13
Location
Ontario (Canada)
Sexuality
100% Straight, 0% Gay
Gender
Male
And I agree that sex, for both you and your partner, is enhanced right after pumping. I find that, if I pump longer than about 20 minutes, there's some de-sensitization which can delay orgasm ... usually a good thing!
Yes this it true! After 30 min of pumping I can stay working for much longer..
 
  • Like
Reactions: cockydude2018

cockydude2018

Superior Member
Joined
Jun 17, 2017
Posts
1,314
Media
0
Likes
7,058
Points
583
Location
Erie, Pennsylvania, United States of America
Sexuality
80% Gay, 20% Straight
Gender
Male
I don’t ever get the “donut” from pumping. I use a smaller cylinder to start, at fairly low vacuum, and I leave it on, increasing vacuum in little increments, for 30 to 45 minutes maybe.

Then I get into a larger tube and do the same thing.

I pumped for more than a hour tonight, and I’m hanging long and thick with no donut, no swelling.
 
  • Like
Reactions: Rewardheragain148

tripod

Legendary Member
Joined
Jan 17, 2006
Posts
6,666
Media
14
Likes
1,832
Points
333
Location
USA
Sexuality
100% Straight, 0% Gay
Gender
Male
Do not apply any sort of constriction device on any portion of your penis during pumping.

Do properly size your tubes. A tube that is too wide can pull in scrotal skin and that will cause a bottleneck of vacuum pressure that will cause most of the pressure to be shifted towards the top of the tube. this results in a more pronounced "donut". The tubes pack sort of top down and more pressure is placed on the head which endangers the glans to blistering.

I use a 1/4" succession of tubes. My first tube might get completely packed in only 20 minutes but I start off in the smallest tube possible for less of a donut effect. Something like a 2" to a 2.25" to a 2.5".
 

randomscore

Experimental Member
Joined
Oct 2, 2019
Posts
6
Media
0
Likes
17
Points
13
Location
Brisbane (Queensland, Australia)
Sexuality
No Response
Gender
Male
Hi mate - noobie here - is there a reason a constriction device should be avoided?

Do not apply any sort of constriction device on any portion of your penis during pumping.

Do properly size your tubes. A tube that is too wide can pull in scrotal skin and that will cause a bottleneck of vacuum pressure that will cause most of the pressure to be shifted towards the top of the tube. this results in a more pronounced "donut". The tubes pack sort of top down and more pressure is placed on the head which endangers the glans to blistering.

I use a 1/4" succession of tubes. My first tube might get completely packed in only 20 minutes but I start off in the smallest tube possible for less of a donut effect. Something like a 2" to a 2.25" to a 2.5".