Quick measuring question

Discussion in 'Sex With a Large Penis' started by xrj789, Feb 18, 2009.

  1. xrj789

    xrj789 Member

    Joined:
    Sep 8, 2007
    Messages:
    120
    Likes Received:
    2
    Gender:
    Male
    Location:
    california
    What's the general rule for measuring girth? My head is big, about 5.75" around when boned up, but the shaft goes down to somewhere between 5.25 and 5.5, depending on where it's measured. What do you guys use as your measurement - where it's thickest or along the shaft?
     
  2. arthurdent

    Gold Member

    Joined:
    Feb 1, 2006
    Messages:
    2,936
    Albums:
    5
    Likes Received:
    339
    Gender:
    Male
    Location:
    High Wycombe (GB)
    Your cock would fit in a UK Velvet toilet roll without touching the sides.
     
  3. hung

    Gold Member

    Joined:
    May 10, 2004
    Messages:
    2,766
    Albums:
    1
    Likes Received:
    51
    Gender:
    Male
    Location:
    USA
    Some measuring sites recommend measuring three different places. The circumfiicene at the glans, the mid shaft and also at the base.

    Compute the total of these three and then divide by three to obtain the average.
     
  4. driftingvoid

    Verified Gold Member

    Joined:
    Nov 8, 2008
    Messages:
    200
    Albums:
    1
    Likes Received:
    3
    Gender:
    Male
    Location:
    Florida
    Verified:
    Photo
    If it's not a consistent girth, measure each differential point and average them.
     
  5. hockeyjock90210

    hockeyjock90210 New Member

    Joined:
    Jan 11, 2008
    Messages:
    44
    Albums:
    1
    Likes Received:
    0
    Gender:
    Male
    Not sure. I wrap a dollar bill around my mid section and its like a 1/4 gap and the ends don't touch. So, guess that's pretty thick but not sure what average is. Have a buddy that gets a 1/2 inch gap when wrapping it around.
     
Draft saved Draft deleted