Did he measure wrong?

[jordanj]

well he might be true check these clips out... Liz Vicious this guy has a very small and thin one...

Looks like a very normal, average penis. Are you selling something here? :tongue:

 

[MaryAnneL]

So what is the "standard" way to measure? Embarassed to say that I havent actually seriously measured a guy before so are there specific ways it should be done?

 

[Amygirl]

Yes, I want to measure my guy but I'm not sure where!

 

[BigA]

I think it's agreed upon that you measure from the top -- where the base of the penis meets your pubes (bottom of your abdoman). However, I am not sure if it is accepted to push, apply pressure with the ruler, into your skin. For instance when I don't push, I am an honest (meager) 6 inches. But if I push into that bit of cushy flesh I can get 6.5. Anyone care to clarify/ elaborate..

 

[fowfer]

BPEL = Bone Pressed Erect Length which elimates the fat pad variable. When measuring for gorwth or other comparisons you want as few variables as possible. Therefore, you should measure with a ruler and a rock hard from the pubic bone(pressed) to the end of the head(do not include forskin)

 

[BigA]

awesome. i can honestly say 6.5 then! i didn't wanna cheat:biggrin1: I'm such a stud

 

[pokerbrat]

I blame the metric system.

 

[rawbone8]

I blame the metric system.

I blame apathy.

 

[Mrs. Candy]

It is exceedingly improbable that his length is 7 inches and circumference 3 inches.

Always,
Mrs. Candy
xx

 

[AlbertCunning]

awesome. i can honestly say 6.5 then! i didn't wanna cheat:biggrin1: I'm such a stud

Amen to that.
I don't have much of a fat-pad myself -- I generally have very little fat on my body-- but even I was able to gain almost a quarter of an inch whilst pressing in, and make it a 6,5".

But will I give up that measurement if the group in general finds this a faulty way of measuring?
Probably not.

 

[Randll86]

I measure from where my dick bends at 90 from my body placing ruler on top not pushed in, I was told this is the correct way to measure, I am about 8.5" measuring that way (pic in gallery) however If I point my dick slightly down & push into the bone measuring along curve I am over 9.5" close to 10". Although who is to say what is the right or wrong way, I don't think there is a rule is there?

 

[episcalo]

3" wide is reallly reallly rrrrreeeaallllllyy big. I'm 2.2" wide (7" circumference), you can compare with my picture to see.

 

[PowayWolfman]

its quite posibel that his dick is in fact 3 inche around... ive ran into a few guys who seemed less than 4